[This would appear to indicate that TeamViewer 14 is interfering with the sound card input. Just for clarity, am I understanding correctly that you connect and the audio drops out, then you disconnect (audio is still gone) and reconnect and at that point the audio is back???
I log in, all is fine, ST running and processing normally. I disconnect, and as soon as the remote TV session exits the processing stops and the NAN error appears. I can log back in and 99% of the time as soon as I connect, the audio processing starts again fine and I can close off the error window. Disconnect again and audio is lost again until I log back in.
O, and is this new in the 9.12 beta's, or is this behavior also there in older versions? I would expect so...
Seems to be the same in all the ST v9.12 betas and ST v9.11, however ST v9.10 I can disconnect and around 40-50% of the time all is fine.
I am not asking TV to send me remote audio for the session so I might look deeper and see if I can either turn off some further options or roll back to TV13 and see if this issue persists.