Stereo Tool

Only a few small changes this time:
- Default values for Natural Dynamics were a bit wrong, now improved
- When loading settings for a specific filter, MB and ND default freqs got reset
- Bojcha's King's Fire 2 preset added
- Windows 64 bit VST version added
- Windows 64 bit stand alone version added. On new systems (2nd or newer generation i3/i5/i7, Windows 7 or 8) it uses AVX for better performance. (VST version as well)

Windows stand alone 32: http://www.stereotool.com/download/ster ... er_731.exe
Windows stand alone 64: http://www.stereotool.com/download/ster ... 64_731.exe
Winamp DSP: http://www.stereotool.com/download/dsp_ ... er_731.exe
Windows VST 32: http://www.stereotool.com/download/vst_ ... ol_731.dll
Windows VST 64: http://www.stereotool.com/download/vst_ ... 64_731.dll

- Singleband Compressor bar (after AGC) added to bottom

If you load a new preset with all information in it (I load normal settings and FM) then RDS is also changed. With Notepad+ I can copy my RDS settings into the new preset, so that's fine. Maybe an idea to have an option to not disturb the RDS settings?

Can you maybe please chance the effect name from the file name to a significant name?

@near05: It should show the correct name. Can you start it? So is your host 64 bits?

When using a VST Rack, would you say it's a good idea when dropping in a new VST version dll, to reload the new dll and re-enter all settings from scratch? Or is it OK to drop the dll in and let the rack re-load settings from a previous version?

I usually re-enter all settings from scratch, just to be safe. But it's kind of a pain. It seems with this version, "Default values for Natural Dynamics were a bit wrong, now improved" implies that if I load 7.31 into a rack that had 7.30, it might use the old values?

Yes i can start it without any problems. but the name is not shown. i am using adobe audition cc (64 bit host).

It should work without re-entering! I never change the values of existing parameters so the only thing that happens when I release a new version is that new parameters may be added at the end of the list; any decent host should just take those new values (defaults) and use them. In this case, for Natural Dynamics the best thing you can do is go to Natural Dynamics -> Initial Boost, and right-click on all the "Subtract" sliders. That gives you the new default values.

Strange, I've tried it in another 64 bit host and the name was displayed properly. And the code is the same as the 32 bit code...