| Stereo Tool https://forums.stereotool.com/ |
|
| Input level bars https://forums.stereotool.com/viewtopic.php?t=7426 |
Page 1 of 1 |
| Author: | ricardomartins [ Tue Feb 23, 2016 2:18 am ] |
| Post subject: | Input level bars |
I've searched the forums but wasn't able to find an answer for my doubt: In the LEVELS frame, there are 5 bars: two that change according to the input and in green, two that remain red and always full (at least in my case) and another one, which is white. What do these bars mean ? Thanks, Ricardo |
|
| Author: | hvz [ Tue Feb 23, 2016 10:20 am ] |
| Post subject: | Re: Input level bars |
First 2: Input. Second 2: Output. Should NOT be red though, so your output is too high. White: MPX level. |
|
| Author: | ricardomartins [ Fri Feb 26, 2016 2:14 pm ] |
| Post subject: | Re: Input level bars |
How can I lower that, Hanz ? I am using only the MPX output, all others are turned down to a minimum. Thanks ! Ricardo |
|
| Author: | hvz [ Fri Feb 26, 2016 2:25 pm ] |
| Post subject: | Re: Input level bars |
Use the Advanced Clipper and make sure Hard Limit is enabled. That should normally fix it. |
|
| Author: | ricardomartins [ Fri Feb 26, 2016 3:00 pm ] |
| Post subject: | Re: Input level bars |
And it did, indeed. Thanks ! |
|
| Page 1 of 1 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|