Stereo Tool
https://forums.stereotool.com/

Central option panel to switch processing sections on/off
https://forums.stereotool.com/viewtopic.php?t=4230		 Page 1 of 1
Author:  sven_x [ Sun Jun 03, 2012 7:54 pm ]
Post subject:  Central option panel to switch processing sections on/off
When trying StereoTool just to correct azimuth only I found that it is hard to disable all not wanted sound processings (to get a clean sound). Currently the settings are distributed across a wide amount of sub-menus.

It would be very helpfull for beginners to add a central option panel, where all processing sections could be switched on or off.
Code:
[x] STEREO IMAGE
   [x] Aizmuth and Channel Delay
   [ ] Stereo Boost on
   [ ] Stereo Image / Flat Stereo
[ ] AUTOMATIC GAIN CONTROL
   [ ] AGS
   [ ] Bass AGC
[ ] NOISE GATE
   [ ] Noise gate (removal)
   [ ] FM Stero hiss removal
[ ] BANDPASS FILTER
[ ] BASS BOOST
[ ] MULTIBAND COMPRESSOR
[ ] LIMITING AND LOUDNESS (FINAL LIMITER)
   [ ] Singleband compressor/limiter
   [ ] Phase rotation
   [ ] Final clipper
   [ ] Hard limit
   [ ] BS-412
   [ ] Lossy compression
--------------------------
[ ] DECLIPPER
[ ] FM TRANSMITTER
   [ ] RDS Encoder
   [ ] Stokkemask
   [ ] Direct soundcard access
Infact I wrote the above list to help myself where to find and switch off the varous options.
Page 1 of 1 All times are UTC+02:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/