Stereo Tool
https://forums.stereotool.com/

Breakaway Live (bypassed as host) Peak Limiter Behaviour ?
https://forums.stereotool.com/viewtopic.php?t=3733		 Page 1 of 1
Author:  michi95 [ Sun Jun 19, 2011 12:31 am ]
Post subject:  Breakaway Live (bypassed as host) Peak Limiter Behaviour ?
Take a look here:
http://www.claessonedwards.com/forum/vi ... f=5&t=2023

(Please answer here, if you are not an active member of the claessonedwards forum).
Author:  hvz [ Sun Jun 19, 2011 6:37 am ]
Post subject:  Re: Breakaway Live (bypassed as host) Peak Limiter Behaviour
Is "Use oversampling to avoid inter-sample peaks" enabled? (Top right of the Loudness&Limiting window)

And HARD LIMIT?
Author:  michi95 [ Sun Jun 19, 2011 7:28 am ]
Post subject:  Re: Breakaway Live (bypassed as host) Peak Limiter Behaviour
Quote:
Is "Use oversampling to avoid inter-sample peaks" enabled? (Top right of the Loudness&Limiting window)

And HARD LIMIT?
Both are enabled.
But it makes no difference if "Use oversampling to avoid inter-sample peaks" is enabled or not.
The chain inside BA Live looks like this:
Stereo Tool :arrow: VB:FFX 4 hosting the to DX wrapped (old Cakewalk VST adpater) TT DR meter VST plugin.
So the output of Stereo Tool (with post amp - 1.00 dB) goes straight to TT DR meter (and this shows correctly - 1.00 dB as max peak).

So the BA Live peak limiter gets this signal (no doubt !).
If I set post amp in ST to +0.08 dB the TT DR meter shows "over" for peak and the BA Live meters shows purple flames (but not if I use +0.00 for post amp).
Author:  michi95 [ Sun Jun 19, 2011 3:58 pm ]
Post subject:  Re: Breakaway Live (bypassed as host) Peak Limiter Behaviour
Problem solved !

It was the BA Live high pass filter (20 Hz - activated by default during BA Live installation).
Details here:
http://www.claessonedwards.com/forum/vi ... b0d#p10550
Page 1 of 1 All times are UTC+02:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/