"matrix-based stereo widener"
What is the idea? for now its crap
you need a width limiter anyway for this
If it is not good, do not build it in ..
| Stereo Tool https://forums.stereotool.com/ |
|
| Stereo Tool 9.03 BETA https://forums.stereotool.com/viewtopic.php?t=25368 |
Page 6 of 16 |
| Author: | Bojcha [ Sat Aug 25, 2018 7:49 pm ] |
| Post subject: | Re: Stereo Tool 9.03 BETA |
Quote:
Stereo boost is disable when I load preset file from the pc BETA903-010
True.
|
|
| Author: | hvz [ Sat Aug 25, 2018 8:28 pm ] |
| Post subject: | Re: Stereo Tool 9.03 BETA |
Quote:
Still NaN's in new stoke
Can you send me your settings? I've ran a lot of audio through it without seeing any NAN's......Also it seems it does not need composite strictness more then 8. Just "Strict post filter" ? Strict post filter sounds bad and leads to volume loss if it does a lot, it's intended to do very little, at strictness 8 it does a lot. I will change that (the new method can also work at Strictness 8) but I need to tweak a number of settings to work properly at each Strictness level, for now (for best results) I've designed and tested it at Strictness 18. |
|
| Author: | hvz [ Sat Aug 25, 2018 8:30 pm ] |
| Post subject: | Re: Stereo Tool 9.03 BETA |
Quote:
Stereo boost is disable when I load preset file from the pc BETA903-010
Ah. Oops. Found and fixed, next build will be ok again.
|
|
| Author: | parelduikerfm [ Sun Aug 26, 2018 6:16 pm ] |
| Post subject: | Re: Stereo Tool 9.03 BETA |
"matrix-based stereo widener" What is the idea? for now its crap you need a width limiter anyway for this If it is not good, do not build it in .. |
|
| Author: | dorian038 [ Sun Aug 26, 2018 7:52 pm ] |
| Post subject: | Re: Stereo Tool 9.03 BETA |
No, I strongly hope that this way of expanding the stereo will be built. Try on an Optimod in the AGC section the matrix mode and you'll see how nice the stereo enlargement is. |
|
| Author: | parelduikerfm [ Sun Aug 26, 2018 7:58 pm ] |
| Post subject: | Re: Stereo Tool 9.03 BETA |
Its not called like "matrix" in Orban  .You can do when you set the AGC into Sum/Diff.Also the Ariane Sequel works in "matrix" leveling what whil enchance your stereo. For now in ST it have bad effects its "jumps and pumping" also fase problems when you set Difference mode and monitoring whith Correlation meter/Vectorscope |
|
| Author: | dorian038 [ Sun Aug 26, 2018 8:36 pm ] |
| Post subject: | Re: Stereo Tool 9.03 BETA |
Yes sorry I confused with the matrix mode in the old AGC stereo tool. But the effect is similar on the Orban. You are right about the name of this model. |
|
| Author: | Bojcha [ Mon Aug 27, 2018 1:03 am ] |
| Post subject: | Re: Stereo Tool 9.03 BETA |
Quote: Quote:
Stereo boost is disable when I load preset file from the pc BETA903-010
Ah. Oops. Found and fixed, next build will be ok again.
|
|
| Author: | octavafm [ Mon Aug 27, 2018 3:31 am ] |
| Post subject: | Re: Stereo Tool 9.03 BETA |
Quote:
Its not called like "matrix" in Orban
I agree .You can do when you set the AGC into Sum/Diff.Also the Ariane Sequel works in "matrix" leveling what whil enchance your stereo. For now in ST it have bad effects its "jumps and pumping" also fase problems when you set Difference mode and monitoring whith Correlation meter/Vectorscope 
|
|
| Author: | GuntherM [ Tue Aug 28, 2018 1:21 am ] | ||
| Post subject: | Re: Stereo Tool 9.03 BETA | ||
Meh! When you apply clipper in MB2 and disable them meters are freezing. Look @ pic. You have to restart ST to reset them.
|
|||
| Page 6 of 16 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|