| Stereo Tool https://forums.stereotool.com/ |
|
| Impact - (new MB - 9 Bands) - by GAP https://forums.stereotool.com/viewtopic.php?t=4686 |
Page 2 of 3 |
| Author: | gpagliaroli [ Tue Mar 12, 2013 4:18 am ] | ||
| Post subject: | Re: Impact - (new MB - 9 Bands) - by GAP | ||
Fixed activation Sidechain EQ, a confusion of "checks", reported to the thread of the current beta version. SingleBand now works as limiter highs (> 5 KHz approx.), Better control of peaks. A little more punch in the bass, because now go directly to Clipper. Comments are welcome! 
|
|||
| Author: | gpagliaroli [ Fri Mar 15, 2013 5:34 am ] | ||
| Post subject: | Re: Impact - (new MB - 9 Bands) - by GAP | ||
Some changes in the AGC and the MB to beta 54. Also changed the slope of the crossover.
|
|||
| Author: | gpagliaroli [ Mon Mar 18, 2013 5:10 am ] | ||
| Post subject: | Re: Impact - (new MB - 9 Bands) - by GAP | ||
Several changes, same objective of sound.  I changed the behavior of the 3 upper bands of MB, passed "Peak" (before RMS) and adjusted times, knee and levels, etc. Some minor adjustments to the AGC and Clipper driver, now Loudness should not vary too when no bass present. Adjusted the SB, for a shorter action, only peaks surplus MB. Small adjustments to BB. Crossover Slope. Well and I think nothing more ...  Made with beta 55
|
|||
| Author: | gpagliaroli [ Fri Mar 22, 2013 5:19 am ] | ||
| Post subject: | Re: Impact - (new MB - 9 Bands) - by GAP | ||
Adjusted the use of limiters in the extreme bands, to beta 60. Some fine adjustments to the MB. This near being the final version ...
|
|||
| Author: | gpagliaroli [ Mon Mar 25, 2013 8:23 pm ] | ||
| Post subject: | Re: Impact - (new MB - 9 Bands) - by GAP | ||
Hans beat me to it ... Final Version!
|
|||
| Author: | Jimbo [ Thu Mar 28, 2013 5:35 am ] |
| Post subject: | Re: Impact - (new MB - 9 Bands) - by GAP |
Curious, why set the pre amp to +20db and Post to -.2 db? |
|
| Author: | Brian [ Fri Mar 29, 2013 7:12 am ] |
| Post subject: | Re: Impact - (new MB - 9 Bands) - by GAP |
Quote: Curious, why set the pre amp to +20db and Post to -.2 db?
Setting the preamp higher handles very soft inputs. Setting post amp to something less than 0 helps make sure that the total output signal doesn't go above 0. That is more the case with presets that do not use Hard Limit.
|
|
| Author: | gpagliaroli [ Fri Mar 29, 2013 4:15 pm ] |
| Post subject: | Re: Impact - (new MB - 9 Bands) - by GAP |
Brain Thanks for answering. In my case, I use the Hard Limit which helps not exceed 0 dB and not generate unwanted cropping. Similarly, there is always the possibility of any uncontrolled peak and that is why I use about 0.25 dB of protection.
|
|
| Author: | Bojcha [ Fri Mar 29, 2013 5:35 pm ] |
| Post subject: | Re: Impact - (new MB - 9 Bands) - by GAP |
Quote: Quote: Curious, why set the pre amp to +20db and Post to -.2 db?
Setting the preamp higher handles very soft inputs. Setting post amp to something less than 0 helps make sure that the total output signal doesn't go above 0. That is more the case with presets that do not use Hard Limit. |
|
| Author: | gpagliaroli [ Fri Mar 29, 2013 9:49 pm ] |
| Post subject: | Re: Impact - (new MB - 9 Bands) - by GAP |
I interpret that, Brian at no time related to the pre-amp output (but I mention it to the post-amp, which is correct). And with respect to the Pre-amp, is much more detailed what you say Bojcha, but with less detail Brain said the same. It's just a little clarification, and thank you both for giving explanations of the case.
|
|
| Page 2 of 3 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|