Stereo Tool

1. Buffer is around 50% always. Buffer size is around 100ms.
2. I don't have that for input2 (?) There is in enterprize version. Should it be in this last beta too?
3. M value is always 1.0000 except when i start ST. after few minutes stabilizes to 1.0000

_________________
control point
control point2

Wait, you were getting this behavior in the Enterprise version, right? Not in the normal version?

Regular, i just realized that new I/O engine is not yet in regular ST. For this ti try i need 32bit version.

_________________
control point
control point2

Ok, I'm going to build a 32 bit version with at most 2 instances (instead of the current 50 for the 64 bit version - more than 2 will probably cause crashes in 32 bit). I think I have also fixed the jumpy behavior that you saw in the Enterprise version.

beta 27, now i see aes67.

but I no longer see the synchronization in fm, is that correct?

That should never have been there. The input syncs to FM, not vice versa (that would cause pilot/RDS issues).

maybe I explained myself wrong.

Ok, while i am waiting.. i tested on different PC and it seems it works. Tested for 8 hours. All buffers seems to stay synced. But i want to also test on site. (still on XP there xD)

_________________
control point
control point2

I had to fix a few things in the build, it's there now in the opening post. I haven't made an installer so it's just the .exe.

Found what's causing this. The FM sync is basically the same thing (!) just with more settings as the input sync - if both input sync and FM are enabled the settings are shared between the two, and you can actually change the settings under FM to control how the input sync works.

We've made this FM sync thing for when you're using a streaming input. And that's not yet supported. That's why you don't see the settings...