Stereo Tool

Hans, no problem of course Works like a charm!

Hans, a good one thanks. Station Playlist released a new version recently, it might be a problem in the stack of the new version. If the problem returns I send a message to the developer of Station Playlist.

I don't have that bug.
If standalone is used (FM) no sound, and with normal output sound is well bypassed.
If Winamp DSP Normal output, again sound is well bypassed.

Hans,
can you check one thing with RDS.

According to "mpxtool" the rds signal strenght is 4.1% if in stereo tool is 4.0%.. so,
for 4.00% i must set exactly 3.90%
for 4.50% i must set exactlly 4.39%
etc..

Are you using ASIO? I've checked the code and I think the ASIO output is broken if you press BYPASS. Normal output seems to work properly (I've also tested that), FM output and Low Latency output in non-ASIO mode should work as normal (stops, also tested that), but in ASIO mode no data is sent to the normal output, which would indeed leed to what you're describing.

I think I have a fix, but I cannot test it here (the ASIO support in my Windows installation is broken ever since I upgraded to Vista64, even ASIO4All doesn't work). Will upload it in a moment.

I can test that with asio ..

To Bojcha and eldoradofm:

I've uploaded a new version of the STAND ALONE version of Stereo Tool. (Only the SSE2 version).

Changes:
- Changed the code to restore the window from tray. I don't know if this solves the size problem because I've never seen it... I only hope that I didn't cause any new issues... Anyway, instead of just restoring it, I'm now actively telling it to go to the last place and size where it was.
- ASIO: Audio should now be played correctly in Bypass mode. But I cannot test that either...

http://www.stereotool.com/download/ster ... r_BETA.exe


Note: Bojcha, are you sure that the window resizing occurred when you played with other windows after minimizing? Because I do think I found a bug - but that's in the code that minimizes the window, NOT in the code that keeps it small or restores it... Anyway, I hope the new code fixes it and then I can just forget about it

Bypass ON - now working using ASIO and FM/Normal output (source sound)

For wider main window after restoring from tray - must report later.

And it didn't before? (If you don't know, never mind - just want to be sure that I really fixed something )

no no .. i know for that bug from erlier .. that's only when ASIO is used!
Now all ok! + now we have any (source) sound when FM output is used.

LOL! I completely missed this. The calculation itself is perfect and would keep the RDS signal exactly at the specified level. BUT there's a lowpass filter used to keep the RDS signal at 57 kHz +/- 2400 Hz. And that lowpass filter isn't perfect. In some cases it causes the RDS signal to be a bit too soft, in others a bit too loud. I'm now scaling the signal by multiplying it by 0.9700, which (based on some measurements) corresponds exactly to the programmed peak level. Just to check: 4.00 * .9700 = 3.88; 4.50 * .9700 = 4.37. Pretty close to your values.