Stereo Tool

Hello ı have a some problem .

ı have 2 radio station in my city but we have rds problem ı have 1 register when i open for 2 radio station rds auto teyp memory problem

1 radio is ok

2 radio auto teyp ; forexsample my radio 1. memory after another radio 2. memory my scond radio and when ı come back 1. memory oooo no memory change

can ı help me for this please

it is "PI" problem.
Put different PI for both stations and stick to it! Try to never change that PI code. For example 8A01 and 8A02.
You can also check what is PI code for your country and put that. Usually first two letters defines country.

_________________
control point
control point2

thank you i will try but can you give me 2 difrent pi code for stereo tool please please ??

ı am from turkey my city is ısparta

Put for radio1 "3030" and for radio2 "3031".

_________________
control point
control point2

We cannot just give you a code. Your code (especially the last 2 digits) must be unique in your reception area. Depending on where you live, you might be free to choose one, or there may be regulations for it. If you use a code that another station already uses, the radio will switch between those two stations, so you might be 'stealing' listeners - which might make the other station pretty angry... Warning: If you change your PI code, you might also loose listeners because some radio's will see that the station that's programmed under a preset isn't there anymore and will try searching for it - in some cases playing silence while searching.

BETA016:

It's been a while. I've been doing lots of things (following up things from the IBC, testing hardware), but I've also been busy optimizing the performance. This new version should behave roughly the same on older systems, but run much faster on newer (i3/5/7) systems. Stokkemask filter (when Faster is enabled, default settings) is a lot more efficient.

Windows 32 bit:
Windows stand alone: http://www.stereotool.com/download/ster ... 51-016.exe
Winamp DSP: http://www.stereotool.com/download/dsp_ ... 51-016.exe

CHANGES:
- Added faster processing paths for SSE3, SSE4.1/2, AXV and AVX2.
- Optimized Stokkemask filter (so far only in Faster mode, will optimize the other modes later). Filtering is slightly less good, although I don't see it in the measurement results.
- Changed band steepness minimum values for multiband from 6 to 3 dB/octave. (Ooh. I hope i changed MB and not ND...).

TO DO:
- Improve web interface further.
- Fix RDS clock on 64 bit
- Add presets


OLDER:
- Added a bunch of new presets. Some need to be updated again. And the Jeroen Platenkamp HvZ mod version is currently identical to the original.
- Web interface drawing of equalizer fixed
- Crash when loading some presets fixed
- Bug fix: Prelimiter acted up at certain latency settings.
- Web interface dragging fixed.
- Bug that caused sliders and top menu to stop working fixed.
- Calculation of FM MPX left/right peaks was wrong when using Composite LIMITER, fixed.
- Made left/right display green (with above 100% yellow) as suggested by mpex2006km.
- Improved web interface a lot more ("1000" is gone, more displays are working, right part of display auto-scales to device width)
- Fix MPX Power calculator
- Fix resetting of tilt calibration when loading a preset
- Add volume meters which show > 100% modulation for IBC demo
- Bug fix: Single-channel file in plugin version caused crashes when using the composite clipper.
- Compressor/limiters: Moved limiter before compressor. This slows down the attack speed when limiting occurs, which gives a more stable sound.
- Improved web interface. (Not yet finished).
- There's some weird sound audible when you enable 'DIFFERENCE' mode. Even if nothing happens. This means that the audio is somehow damaged. It's worse at lower latency settings. FIXED
- Make highs clipping level configurable. DONE
- Fix composite clipper mode. DONE
- See a few posts up. I've now added 2 sliders that can be used to reduce the effect when there's not clearly a tone present. Tones only reduces the effect when there isn't a single tone that clearly sticks out - basically it checks how loud the strongest band is vs. the total of all bands, and adjusts the effect based on the result of that calculation. Since there are almost always also other tones present, setting this too high will even reduce tones that do clearly stick out. Tones threshold can be used to turn the filter off completely if there isn't a single tone that clearly sticks out (it makes the slope of the Tones only effect steeper).
- Changed some things back to how they were in version 005 - Bojcha reported (and I confirmed) some weird artifacts in version 006. If you enable METHOD2 you get the 006 behavior, that's for my own tests and I will remove METHOD2 later.
- Added Smother filter. The higher you set it, the more it will ONLY affect the loudest sounds. If you have multiple loud tones (for example a bass and a loud voice), setting this very high might cause only one of the two to be effected - setting it very low will affect everything though.
- Added multiband pre-limiter/phase optimizer to the Advanced Clipper.
- Trying a different multiband limiter in the Advanced Clipper. This time without phase optimizer. I'm very curious which version you guys prefer!

Using lower limiting levels lowers the loudest sounds in the mix. Since bass is often the loudest sound it tends to reduce bass more than other sounds.

What are those FFFFFFF in the CPU load panel ?. Some new one to show what ?

Just to do a cpu load diffrence between last release version and this beta I used Bochja Ibiza FM preset

Last release: 29%-32%
Last beta: 13%-20% less stable in the load

Having this said, I overinstalled the last release with this beta and immediately I got screen errors occured. So I did factory reset and than I could search for the Bochja Ibiza FM preset.

Inveil and centurion including HVZ mods are not working. And causing errors, probably the cause of the errors when over installed Stereotool.


CPU Load down is great!

So far my first results


EDIT:

The FM meter (demodulated audio) won't go to 100%


Broken presets:
Beat THIS
Big Six FM
Fat Bass
Nitro 3 bands
Loud 'n clear
Open Wide

all in the FM europe section

_________________
The Power of Sound

''Music is a moral law. It gives soul to the universe, wings to the mind, flight to the imagination, and charm and gaiety to life and to everything.'' - Plato

I don't get this affinity..
And yes, band steepness to 3dB/otc is in ND MB.

_________________
control point
control point2

On Old athlon 4850e no difference , or may be 3-4% diff in comparision to latest beta . i mean latest before changes with libraries and latest now.