Stereo Tool

Also 4 % less CPU on our Breakaway-Server-PC. Before 30 %, after 26 %...

Something is wrong with the dsp version, at least with my settings, which worked fine with beta52
No output, flickering in the MB levels display, Advanced clipper full colored display

VST works fine in Audition, same settings

AMD A8-3870 , win7 64

Will stereo separation be fixed in compressor(s)?

For me is CPU : 25 31% .. average 28 % . GOOD

I really need to make a list of things that need to be fixed before I can release this version. Please let me know if I miss anything:

- Show 1 or 2 AGC bands in bottom meters is 1 or 2 used. -> Annoying side effects, not going to do this now.
- I think I should probably remove the 'Use side chain' button, to make it work the same as all other side chains.
- I think I need to put the top line of Multiband sliders (which are very small) in a separate page.
- Add hold multiplier; in Simple mode replace all multipliers by one.
- And change the scale of the Drive slider indeed. -> Probably affects ALL sliders with values in dB's!
- Compressor: Fix stereo separation in Peak mode
- Multiband Compressor: Display coupled bands - Done, but without coupling is no longer visible!
- Multiband Compressor: Median displays (new MB only)
- Remove "blob" from Knee
- Equalizer: More resolution for lower bands - Twice as steep allowed now. #define peq_steep.
- Sound cards: Make 'Synchronize to output' work with Normal output To be tested; might crash/hang
- Multiband compressor: Differentiate between Basic/Advanced/Extreme... modes
- Singleband Compressor: Differentiate between Basic/Advanced/Extreme... modes
- Compressor side chain causes volume jumps (block overlap issue).
- Some default logical Band crossover settings for MB (every number of bands)
- Check Wunjo's issue with BETA053 (very likely either a memory alignment or a too-aggressive-optimization problem). Appears to be in the "Knee" code. (Error in LUT?)
- Crash reported by Christian Steifen: If you change to a different category and quickly change something it crashes (VST version).
- Hosts issue
- Update presets
- Change version number
- Release

[quote="Wunjo"]Something is wrong with the dsp version, at least with my settings, which worked fine with beta52
No output, flickering in the MB levels display, Advanced clipper full colored display
Could you send me your .ini file in a PM? With this STS file I cannot reproduce the issue....

It sounds like the MB is outputting invalid values (Not A Number or NaN, which can result in overflows in the next filters).

@Hans,
What do you think of this?

_________________
by GAP
"Less is More" (Bob Katz)

What about EQs ?
- More resolution for lower bands
- Peq Sliders (?)

- Show 1 or 2 AGC bands in bottom meters is 1 or 2 used.
- Some default logical Band crossover settings for MB (every number of bands)

..

I think I should probably remove the 'Use side chain' button, to make it work the same as all other side chains.
Ah, good one. I think I need to put the top line of sliders (which are very small) in a separate page. But also change the scale of this Drive slider indeed.

Added most of these to the list; Peq sliders probably later but I'm not going to do that now. (Not going to hold off the release of a new version for that).