| Stereo Tool https://forums.stereotool.com/ |
|
| RMS level mismatch https://forums.stereotool.com/viewtopic.php?t=7925 |
Page 1 of 1 |
| Author: | \_/ [ Thu Jul 21, 2016 5:15 pm ] |
| Post subject: | RMS level mismatch |
If one feeds enough 1s over a long time to a compressor then the level detection should obviously become 1 too, no matter if one uses max, mean, RMS or whatever to sense the level. The ST analog RMS (compatibility) compressor however is off a few dB, peak mode is fine though. How can that be? |
|
| Author: | hvz [ Fri Jul 22, 2016 2:00 am ] |
| Post subject: | Re: RMS level mismatch |
If I recall correctly, I've set it up such that the levels for sine waves are the same. That is not correct behavior, but it does make it a lot easier to switch between peak and RMS mode without big volume differences. |
|
| Page 1 of 1 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|