Stereo Tool
https://forums.stereotool.com/

Release to signal
https://forums.stereotool.com/viewtopic.php?t=7165		 Page 1 of 1
Author:  \_/ [ Tue Nov 17, 2015 2:23 pm ]
Post subject:  Release to signal
Usually compressors release to 0 but some release to the signal. Assuming that ST does the former is it possible to simulate the latter?
Author:  hvz [ Tue Nov 17, 2015 2:33 pm ]
Post subject:  Re: Release to signal
It already does that (in Analog mode).
Author:  \_/ [ Tue Nov 17, 2015 4:07 pm ]
Post subject:  Re: Release to signal
Nice, that should make it easy.

Since there's no online help for the analog compressor, some questions:
  1. With maximum ratio and other settings equal, the analog compressor has 3 dB less reduction for white noise in peak mode than the digital one. Why (non-standard peak measurement)? Which one is right?
  2. What are the peak mode slider and lowpass for?
Edit: I found out that the lowpass is for the control signal. Does this interfere with the sidechain?
Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/