I am attempting to do some work with ST in a mediumwave project and can't seem to figure out how to get the Normal Output to be mono-only. How do you set Stereo Tool to output a mono L+R signal in Normal Output?
Thanks in advance.
| Stereo Tool https://forums.stereotool.com/ |
|
| Mono downmix for "Normal Output"? https://forums.stereotool.com/viewtopic.php?t=5525 |
Page 1 of 1 |
| Author: | jwjstudios [ Mon Mar 10, 2014 11:47 pm ] |
| Post subject: | Mono downmix for "Normal Output"? |
I am attempting to do some work with ST in a mediumwave project and can't seem to figure out how to get the Normal Output to be mono-only. How do you set Stereo Tool to output a mono L+R signal in Normal Output? Thanks in advance.
|
|
| Author: | hvz [ Tue Mar 11, 2014 12:33 am ] |
| Post subject: | Re: Mono downmix for "Normal Output"? |
Only Normal Output or all outputs? If all outputs: Go to Stereo -> Stereo Image and move both 'Phase' and 'Width' slider to 0%. This will downmix without frequency cancellation between channels. |
|
| Page 1 of 1 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|