| Stereo Tool https://forums.stereotool.com/ |
|
| Jack cable from Trace Alpha to BNC https://forums.stereotool.com/viewtopic.php?t=4938 |
Page 1 of 1 |
| Author: | Edgar [ Sat Aug 24, 2013 12:08 pm ] |
| Post subject: | Jack cable from Trace Alpha to BNC |
I have found a coax RG59 cable with a BNC connector at one side. I have made a 6,3 mm Neutrik jack connector on that. It works, but for sure I will know if I made the right connection to put the main wire into the tip and the ground part at the sleeve/shield. I use the stereo version of the Neutrik jackplug NP3x, I know with BNC you only have two wires. Thanks |
|
| Author: | Clipper [ Sat Aug 24, 2013 1:50 pm ] |
| Post subject: | Re: Jack cable from Trace Alpha to BNC |
MPX is unbalanced so you only need to use the Tip and Sleeve. |
|
| Author: | bob53bob [ Sun Aug 25, 2013 12:40 am ] |
| Post subject: | Re: Jack cable from Trace Alpha to BNC |
Here's what I did...converts the Trace Alpha's output to a BNC female jack...same jack used by all broadcast processors. http://www.jameco.com/1/1/50898-1297-bn ... -plug.html |
|
| Page 1 of 1 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|