something went wrong! Loudness is at 0 and pre-amp at 1... etc.
I might be using other beta version on other PC. No, there is letter 'a' at start of preset.
Correct version!
Attachment:
| Stereo Tool https://forums.stereotool.com/ |
|
| Neodymium - Streaming preset ST6.20 https://forums.stereotool.com/viewtopic.php?t=3815 |
Page 1 of 2 |
| Author: | Bojcha [ Sat Oct 08, 2011 3:12 pm ] |
| Post subject: | Neodymium - Streaming preset ST6.20 |
After many variations and versions this is my RC1 of preset. (used Standalone ST6.20_beta127) Attachment:
If someone finds something sounds distorted or in any way bad, please inform me.
|
|
| Author: | Bojcha [ Sun Oct 09, 2011 1:20 am ] |
| Post subject: | Re: Neodymium - Streaming preset ST6.20 |
something went wrong! Loudness is at 0 and pre-amp at 1... etc. I might be using other beta version on other PC. No, there is letter 'a' at start of preset. Correct version! Attachment:
|
|
| Author: | Brian [ Mon Oct 10, 2011 9:16 am ] |
| Post subject: | Re: Neodymium - Streaming preset ST6.20 |
Only comments are that I think that the center frequencies now give this one just a little bit too much upper mids and highs, and maybe not quite enough sub-bass/bass. That could be RMS level differences though, as this is a louder RMS preset than what I just posted. It also has less dynamic range, as measured by that TT Offline DR meter. |
|
| Author: | Bojcha [ Mon Oct 10, 2011 1:27 pm ] |
| Post subject: | Re: Neodymium - Streaming preset ST6.20 |
Yes Brian, that was point with this preset to open as much as possible mid-highs and highs and to stay clean. Also as much as possible highs RMS but to keep dynamics. I already have update with bass which i was't liked too. (still testing.) |
|
| Author: | eurodancetest [ Mon Oct 10, 2011 4:03 pm ] |
| Post subject: | Re: Neodymium - Streaming preset ST6.20 |
I'm using your preset, and for my music it had too much bass, so I edited it a bit. But you can feel the volume rising, when i fade from a very loud track to a very quiet one. It takes about 5 seconds to restore the volume... |
|
| Author: | Bojcha [ Mon Oct 10, 2011 4:08 pm ] |
| Post subject: | Re: Neodymium - Streaming preset ST6.20 |
Quote: I'm using your preset, and for my music it had too much bass, so I edited it a bit. See.. for someone subbass and bass ar bit lower, for you it's too much.  Quote: But you can feel the volume rising, when i fade from a very loud track to a very quiet one. It takes about 5 seconds to restore the volume... What are those two tracks ?
|
|
| Author: | Brian [ Mon Oct 10, 2011 7:18 pm ] |
| Post subject: | Re: Neodymium - Streaming preset ST6.20 |
Quote: Quote: I'm using your preset, and for my music it had too much bass, so I edited it a bit. See.. for someone subbass and bass ar bit lower, for you it's too much.
 Quote: Quote: But you can feel the volume rising, when i fade from a very loud track to a very quiet one. It takes about 5 seconds to restore the volume... What are those two tracks ? 
|
|
| Author: | Bojcha [ Mon Oct 10, 2011 9:15 pm ] |
| Post subject: | Re: Neodymium - Streaming preset ST6.20 |
Here's update. More bass (mostly on constant bass sounds), less bass pumping, bit lowered mid-highs and super-highs. Attachment:
...
|
|
| Author: | gpagliaroli [ Fri Oct 14, 2011 7:15 pm ] |
| Post subject: | Re: Neodymium - Streaming preset ST6.20 |
good job!
|
|
| Author: | Bojcha [ Fri Oct 14, 2011 7:36 pm ] |
| Post subject: | Re: Neodymium - Streaming preset ST6.20 |
Thanks G  Update again will come... I forgot to test it with other tests like commercials vs different productions so i had some different rms levels. Also i bring monitor spekers from radio to my home to tweak better some sounds. (don't tell to my boss) so - Tighter limiting - even better and tighter bass - Better preserving RMS .. is comming. |
|
| Page 1 of 2 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|