| Stereo Tool https://forums.stereotool.com/ |
|
| Output Level https://forums.stereotool.com/viewtopic.php?t=28976 |
Page 1 of 1 |
| Author: | Willem [ Thu Sep 03, 2020 1:16 pm ] |
| Post subject: | Output Level |
Hello, maybe a very simple question for you guys, but I just can't figure it out. My output level is at max (at least I think so), barely see it moving / coming back. Everything else is running fine. How can I lower it. See videos on you tube that are almost the same as mine, don't know if I should adjust this? Thanks in advance! Greetings Willem |
|
| Author: | Studio 11 [ Thu Sep 03, 2020 2:06 pm ] |
| Post subject: | Re: Output Level |
Output volume can be adjusted under I/O > Sound Cards. Choose the output that you are using and adjust the volume bar. But if you barely see it moving, it means that either you're driving the clipper very hard or the output from multiband is not adjusted corresponding to the multiband drive. If you like the sound as is, just lower the volume, if you have a very dense and busy sound, lower one of the above mentioned. |
|
| Author: | Willem [ Thu Sep 03, 2020 2:24 pm ] |
| Post subject: | Re: Output Level |
Thank you very much for your reply, I will check it tonight. Kind regards Willem |
|
| Page 1 of 1 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|