Stereo Tool
https://forums.stereotool.com/

Phase-Correlation Meter
https://forums.stereotool.com/viewtopic.php?t=23383		 Page 1 of 1
Author:  octavafm [ Tue Nov 14, 2017 2:01 am ]
Post subject:  Phase-Correlation Meter
Hi:
It would be nice to integrate a phase-correlation meter, where it is displayed in a VU [-1 ... 0 ... +1]
A good place would be below the Azimuth Analizer.

Best regards from Chile.-
Author:  near05 [ Tue Nov 14, 2017 6:43 pm ]
Post subject:  Re: Phase-Correlation Meter
Quote:
Hi:
It would be nice to integrate a xxxxx, where it is displayed in a VU [-1 ... 0 ... +1]
A good place would be below the Azimuth Analizer.

Best regards from Chile.-
I can only contribute to this good idea! Already during the test phase of the new beta version I had the idea that, if there is already a goniometer, a phase correlation meter would not be bad. But then it would be necessary to consider whether you should install 2 of them (before and after) as with the goniometer.
Author:  octavafm [ Wed Nov 15, 2017 5:01 pm ]
Post subject:  Re: Phase-Correlation Meter
Quote:
Quote:
Hi:
It would be nice to integrate a xxxxx, where it is displayed in a VU [-1 ... 0 ... +1]
A good place would be below the Azimuth Analizer.

Best regards from Chile.-
I can only contribute to this good idea! Already during the test phase of the new beta version I had the idea that, if there is already a goniometer, a phase correlation meter would not be bad. But then it would be necessary to consider whether you should install 2 of them (before and after) as with the goniometer.
:D very good contribution near05
Page 1 of 1 All times are UTC+02:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/