Remove remaining peaks: Switch added to switch between 'stereo' processing (as before) or 'near-mono' (max. difference in 'remove remaining peaks' between channels is 2 dB, maybe I should make that value configurable...).
Winamp DSP plugin: http://www.stereotool.com/download/dsp_ ... 20-008.exe
Stand alone version: http://www.stereotool.com/download/ster ... 20-008.exe
VST version: http://www.stereotool.com/download/vst_ ... 20-008.dll
VST version (No SSE2): http://www.stereotool.com/download/vst_ ... 20-008.dll
Command line version: http://www.stereotool.com/download/ster ... 20-008.exe
Linux command line version: http://www.stereotool.com/download/ster ... ETA620-008 NOT AVAILABLE
Linux GUI version: http://www.stereotool.com/download/ster ... ETA620-008 NOT AVAILABLE
TODO:
- Add buffer for SCA output 1 day
- Finish AGC improvement ? - make mono value configurable (replace checkbox by slider) 1 hour --> NO, not needed - anything else needed?
- Fix Punch making it dynamic will cost 1 day
- Check what to do with new filters (such as bass AGC) - keep them, remove them, change them?
- Loudness: Annoying cracking sound in bass. Slightly present in 5.00, worse in 6.00, maybe even worse in 6.10. Only when bass is too loud. Much worse than in Final Limiter (at same input level!) - so this clearly indicates a bug. Most likely cause: The filter that was added to remove bass artifacts.......
- Change version number 1 hour
- Release 1 hour
Bojcha: About Punch: Doesn't it help if you increase the Punch slider? The difference with before is that I now don't increase the level of soft sounds (which MIGHT mean that some details in the sound get lost...). I could make it act more like in version 6.00, but then I need to dynamically slide between 6.00 Punch when no or little bass is present upto 6.10 Punch when a loud low bass is present, this is needed to reduce bass artifacts caused by Punch.