Stereo Tool
https://forums.stereotool.com/

Stereo Tool 3.40 BETA
https://forums.stereotool.com/viewtopic.php?t=102		 Page 6 of 6
Author:  vamprecords [ Sat Nov 22, 2008 7:53 pm ]
Post subject:  Re: Stereo Tool 3.40 BETA
Quote:
Vamprecords: Klinkt lekker! Heb vanavond weinig tijd om te luisteren, maar wat ik tot nu toe hoor klinkt lekker krachtig. Gebruik je op dit moment Loudness? (En zo ja, hoe hard?)

Jah ik gebruik loudness, momenteel op standje 1,95.
Author:  DJ-DOGGY [ Tue Dec 02, 2008 7:22 pm ]
Post subject:  Re: Stereo Tool 3.40 BETA
Hello Hans , Did you receive my e-mail about my idea ?
Author:  hvz [ Tue Dec 02, 2008 8:29 pm ]
Post subject:  Re: Stereo Tool 3.40 BETA
Hi DJ Doggy,

Sorry I didn't respond earlier - I've just sent you an email.
Author:  hvz [ Tue Dec 02, 2008 8:34 pm ]
Post subject:  Re: Stereo Tool 3.40 BETA
I have made a few improvements to the 3.40 beta:
  • Found and solved a bug in the "HARD LIMIT" filter that caused high frequencies to be reduced by about 1 dB. This bug only occurred when FM transmitter support was used.
  • Loudness filter: CPU load reduced.
  • Loudness filter: Harshness of the sound greatly reduced.
  • Loudness filter: Allowed a small amount of distortion on the high frequencies if there's a lot of high frequency content (which will mask the distortion), to reduce ringing artifacts ("low quality mp3"-like sounds) and increase the amount of high frequency content in the result. Has very little effect when FM pre-emphasis is not used.
  • Loudness filter: Added an extra filter to reduce ringing and other artifacts.
So basically when using the Loudness filter and/or FM output the highs are now both clearer and louder.

The result is available on the download page.
Author:  tekie [ Wed Dec 03, 2008 2:40 am ]
Post subject:  Re: Stereo Tool 3.40 BETA
Looking MUCH better, Hans. :geek:
Author:  hdmyg228 [ Wed Jan 07, 2009 3:18 am ]
Post subject:  Brass air fittings
Now that is a lot of brass air fittings http://www.liangdianup.com/subpages/airfitting_1.htm there is just about every type
of air fitting that you could want. Wholesale prices too. I guess these could be used as small water pipe fitting also. I
used some of the parts to make my babington wvo burner.
Page 6 of 6 All times are UTC+02:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/