| Stereo Tool https://forums.stereotool.com/ |
|
| Stereo Tool 7.32 BETA https://forums.stereotool.com/viewtopic.php?t=4989 |
Page 4 of 30 |
| Author: | Valiant [ Fri Oct 11, 2013 6:09 pm ] |
| Post subject: | Re: Stereo Tool 7.32 BETA |
Quote: The full screen mode looks nice on my second display
Yes, I have more than 1 monitor. Quote: Do you have more than 1 monitor???  Yes, The second monitor makes a difference.... Turning the second one off, it seems to stop the "Always On Top" effect I was getting with both SA & DSP. Unfortunately, the disappearing button effect is still there on the SA only |
|
| Author: | Bojcha [ Fri Oct 11, 2013 7:50 pm ] |
| Post subject: | Re: Stereo Tool 7.32 BETA |
hey i also use 2 monitors.. and ST is usually placed on 2nd. |
|
| Author: | hvz [ Fri Oct 18, 2013 11:11 am ] |
| Post subject: | Re: Stereo Tool 7.32 BETA |
Windows stand alone: http://www.stereotool.com/download/ster ... 32-006.exe Winamp DSP: http://www.stereotool.com/download/dsp_ ... 32-006.exe Windows VST: http://www.stereotool.com/download/vst_ ... 32-006.dll - AGC improvement: Bojcha reported that the AGC gives a much more consistent output at lower latency settings. Now, at higher latency settings you can replicate the lower latency settings behavior (See AGC -> Bands -> Block size; suggested value is 1024). |
|
| Author: | hvz [ Fri Oct 18, 2013 11:19 am ] |
| Post subject: | Re: Stereo Tool 7.32 BETA |
Quote: @hvz: In the AGC -> Compressor, if disabled, is always enabled "Limit Distort"
Fixed in next version
 |
|
| Author: | hvz [ Fri Oct 18, 2013 1:46 pm ] |
| Post subject: | Re: Stereo Tool 7.32 BETA |
Quote: 1 When first window is opened (after install), the full screen button appears however, after ST program was closed and opened again later, it is no longer there. (I am set at Extreme Tweaker)
Should be fixed now (next beta).
|
|
| Author: | gpagliaroli [ Sun Oct 20, 2013 6:31 am ] |
| Post subject: | Re: Stereo Tool 7.32 BETA |
I suggest lowering the maximum gain value in the Mix of MB, as 20 dB is too much and causes you to lose accuracy for lower values, are saying? 
|
|
| Author: | dj_szpajda [ Sun Oct 20, 2013 12:40 pm ] |
| Post subject: | Re: Stereo Tool 7.32 BETA |
Hmm I made some direct comparison 7.31 stable to lastest beta and 7.31 has fuller sound in mid range with same my preset. Is it possible? |
|
| Author: | Valiant [ Wed Oct 23, 2013 12:20 pm ] |
| Post subject: | Re: Stereo Tool 7.32 BETA |
Quote: Quote:
1 When first window is opened (after install), the full screen button appears however, after ST program was closed and opened again later, it is no longer there. (I am set at Extreme Tweaker)
Should be fixed now (next beta). I typically install the SA to my D Drive which I have placed a shortcut icon on my desktop to access with. In the past this has never been a problem (every version). Somehow with this beta it got installed to the C Drive instead of the D Drive. At install it opened from the C Drive and showed the version with the Full screen button, then when I closed it and opened with my desktop icon, the version on the D Drive opened (without the Full screen button).  I guess I have stopped paying attention to where it was being installed to because in the past it has gone to the correct folder without me changing the destination at install. I am not sure how or why it did this this time and I have tried to go back and recreate how it happened, but I guess it was just human error. |
|
| Author: | hvz [ Fri Oct 25, 2013 10:05 am ] |
| Post subject: | Re: Stereo Tool 7.32 BETA |
Windows stand alone: http://www.stereotool.com/download/ster ... 32-007.exe Winamp DSP: http://www.stereotool.com/download/dsp_ ... 32-007.exe Windows VST: http://www.stereotool.com/download/vst_ ... 32-007.dll - Limiter improvement: Bojcha reported that the compressors (mainly the limiters) give a much more consistent output at lower latency settings. Now, at higher latency settings you can replicate the lower latency settings behavior (See the 'Block size' parameter (under 'detection'), available for all compressors (singleband and multiband per band). Very low settings can cause bass intermodulation distortion. |
|
| Author: | hvz [ Sat Oct 26, 2013 2:14 pm ] |
| Post subject: | Re: Stereo Tool 7.32 BETA |
I got a request several times, and yesterday I decided to implement it: Multi-language support.  Windows stand alone: http://www.stereotool.com/download/ster ... 32-008.exe Winamp DSP: http://www.stereotool.com/download/dsp_ ... 32-008.exe Windows VST: http://www.stereotool.com/download/vst_ ... 32-008.dll Dutch language file (not completely translated yet, but more than 50% is done): http://www.stereotool.com/download/Nederlands.stl Place it in the same file as the Stereo Tool binary (DLL or EXE file). After restarting Stereo Tool you can select it in the Configuration window, under Language. If you use Extreme Tweaker mode, there's also an option to export the current language info to a file called Export.stl. |
|
| Page 4 of 30 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|