Stereo Tool

Windows 32 bit:
Windows stand alone: http://www.stereotool.com/download/ster ... 52-002.exe
Winamp DSP: http://www.stereotool.com/download/dsp_ ... 52-002.exe

CHANGES:
- PNR analysis data is saved now

PREVIOUS:
- Added PNR Noise & Hum

Note: If you change the Latency or Quality setting or the number of audio channels, the filter is turned off! Analysis is specific to those settings.

It's still enabled when "reset all/prn settings" and Turns ON with any preset loaded.

_________________
control point
control point2

Ow. I guess I turned it on by default for testing purposes before I added it to the GUI. Will fix that in the next version. (If you don't do an analysis, it doesn't have any effect).

Next bèta (tonight) has some small changes that should make the output spectrum of Advanced Bass Distortion Protection flatter. I haven't really changed much but some filter frequencies have been moved a bit to reduce holes in the spectrum.

Great.
Do you mean you test my test sound that i posted on previous version thread ?

No this is a completely different issue. I'm talking about the spectrum (when you feed it pink noise). There were some bumps in it, which is bad. And the new version sounds fuller and more open to me (there's also slightly more intermodulation distortion, but my first impression is that this is really better).

Will upload it in a moment!

Windows 32 bit:
Windows stand alone: http://www.stereotool.com/download/ster ... 52-003.exe
Winamp DSP: http://www.stereotool.com/download/dsp_ ... 52-003.exe

CHANGES:
- Advanced Clipper: Advanced Bass Distortion Protection (ABDP): Drop in output when strongly clipping around 2600-4000 Hz is reduced.
- Advanced Clipper: ABDP: "Smooth Slide" slider added to make transition between deep bass (clipped) and less deep bass smoother. There used to be a drop upto the 2nd configured bass frequency, with this switch enabled the drop is smoothed (maximum at 1st configured bass freq, gone at 2nd). Result: Warmer, more open, less 'restrained' sound. But probably also a bit more intermodulation distortion. (which might be fixable by changing the frequencies a bit). (*)

TODO:
- Display FM lowpass frequency at bottom when FM output is used.

(*) If you don't hear the difference, try this: In ABDP, set the 2 bass frequency sliders both to 0. This will completely kill the bass. Now, turn the Smooth Slope setting on and off. The same effect is also present at normal settings, just less extreme.

PREVIOUS:
- Added PNR Noise & Hum
- PNR analysis data is saved now

Note: If you change the Latency or Quality setting or the number of audio channels, the filter is turned off! Analysis is specific to those settings.

hmm , distortion ? I don`t like any type of distortion
Will be good to know how with new sliders/options i can make it like they are not present .. I mean to be like or till this beta. Will test but i don`t like dostortion.

Just try it out... There could be more distortion but based on my (very limited) tests so far it's very little, and the sound does get much warmer and more open.

And you can turn that new setting off.... and if you only clip a bit there's probably no difference at all.

Alright, i`ll test it to see