Stereo Tool

Intel normally also reports ffffffffffffffff, I'm not sure what's going on here. It could still be that there are 2 bugs (but if so, they show up in the same line of code).

Exeption reported by me is fixed.....

Memory usage increased by around 6-7 Mb compared to beta21

Huh? It should be decreased further...

Thanks - load per core also looks fine from what I can see. This is being run under the same conditions on a test pc so there shouldn't be anything else too problematic in terms of software / CPU load issues - I can keep an eye out for what you suggest though.Synchronize to output is off. FM transmitter synchronization was ticked but greyed out - I've subsequently disabled that now. Yes - I've tried earlier betas and I suspect this is possible - I normally just run the new betas for a few hours for a while when mucking about / listening to music so it's hard to tell for sure.

I'm trying Beta 022 now. I think I heard another glitch but they are so few and far between it's difficult to be sure exactly what's happening.
Something else - enabling FM Tilt correction seems to lock up the GUI. Having a look at the exception log :

Exception in: Display VU Meters (Exception 0xc0000005 at address 0x1bef658, read/write=0, r/w location=0x11c). Offset-info: 0x13756d4
Restarting: NO

If you don`t use synchronize option , you will get after some time "empty buffer" and then is almost 100% sure you can get those glitchesor whatever you call it.

I again will said: if you can , record them , i want to hear what is it , so i can tell you if i have them too

mmm, no
Beta21 was around 124 000 kB , beta 22 shows around 130 000 kb


EDIT : COnfirm the locking up the GUI when Enable the tilt correction.Then it start locked up after close.
Exactly same text in ST log.

Only if you use different sound cards for input and output (a virtual cable is also a sound card). Those glitches would get very bad after a while, so it could be that - but the buffer meter would show something.

Yes, only with different .
You mean if i use Realtek Input for input and Realtek Output as output , i can disable the synchro and buffer will not empty after some hours/days ?

For the buffer : I see that in 7.60(may be in 7.70 too) the input buffer meter is solid at 100% .
But in last betas( may be at the begginning of developing 7.71) it shows some very little jumpings around "the 100%".
I`m not saying it`s a bug , may be this is the right behavour, not like it was.
Size is at default 0.000 sec

stereo image, or the program may be a better stereo booster stereospecific expander plug-in has to be very bad sound discrimination

Cause of crashes in Tilt correction is fixed now - I will run a new build.