Stereo Tool

Sorry - they are now!

Try now.

What happened with "True Peek". Also what is value?

_________________
control point
control point2

Looks like there is no effect of 1% reduced modulation , reported as change in this version. Now point of beginning is -70dB , was at -80 dB previous beta14 . Look red line on the picture , starts to fall wrong at -70. Turn back some pages ago to see how this line starts to go "wrong" at -105 dB in the "perfect version" - that`s what i call it
It`s getting worse . Looks like it`s not from modulation but from somewhere else . You can turn back this change , because this 1% has no effect on this issue.

Also "Ignore freqiencies" issue still there - both (jumping noise floor and unwanted moving spike signal)

It is overruled by Stokkemask. Value depends on other settings - usually it will be the same as the slider to it's left.

Are you using the stand alone version? Which output are you looking at and what is the Volume slider set to?

Yes, Stand alone .
I`m looking FM output (whole MPX). And slider of this output is set to 100% ( 0.00 dB) . I try to set it to -1.00 dB , to -3.00 , but this (whole MPX) is just getting down by the amount of decibels WITHOUT change it`s shape . This on picture NOT disappears, stays the same but with less amplitude!

The noise floor jumps should disappear as soon as you lower it below 99%. I'm looking at the other issue now.

No, i test even this . Not disappeared even with 84.5 % ( around 1.40 dB lower). Even at -2.00 dB too. Same thing- just lower the whole signal by 2.00 dB and all jumping is same. Let say at 0.00 jumping is to -100 . With -2.00dB , jumping is to -98 . No any change in behavour.

These issues are in the forming of signal , not in it`s amplitude. I can prove all my words with video.
It can be easy tested , by enabling and disabling the Advanced clipper . When disabled , you will have to lower the output slider of FM to around -10 , -12 dB , because highs are "Free" and peaks will cause overmodulation. This will show up the slope shape with and without Advanced clipper. I must be clearly visible.

Ok, here is this
Video with clear difference that Advanced clipper causing all i`m talking about. I made output slider just how you tell me , even lower. No change . This is only for "over signal" issue . I can make one for jumping and spike to see it`s still there.


http://www81.zippyshare.com/v/pduRWTW2/file.html

Download it if not running from web.