Stereo Tool
https://forums.stereotool.com/

Weird GUI artifact...
https://forums.stereotool.com/viewtopic.php?f=6&t=33242
Page 1 of 1

Author:  baldrick_nz [ Sun Jul 31, 2022 4:44 am ]
Post subject:  Weird GUI artifact...

Hi all,

I've just noticed some overlap on either side of the 19kHz pilot signal and was wondering whether it's normal, and if not, what can be done to remove it?

The low pass to the TX is set at 16.1kHz in ST, so I would have thought a 2.9kHz buffer would have been enough.

https://imgur.com/a/oX2iIli

Cheers,
Baldrick

Author:  baldrick_nz [ Wed Aug 03, 2022 10:04 pm ]
Post subject:  Re: Weird GUI artifact...

Bump...

Author:  xristostsilis [ Thu Aug 04, 2022 7:36 am ]
Post subject:  Re: Weird GUI artifact...

Quote:
Hi all,

I've just noticed some overlap on either side of the 19kHz pilot signal and was wondering whether it's normal, and if not, what can be done to remove it?

The low pass to the TX is set at 16.1kHz in ST, so I would have thought a 2.9kHz buffer would have been enough.

https://imgur.com/a/oX2iIli

Cheers,
Baldrick
Never seen that. Where’s your quality slider at?

Author:  baldrick_nz [ Sun Aug 07, 2022 7:38 am ]
Post subject:  Re: Weird GUI artifact...

Quote:
Never seen that. Where’s your quality slider at?
Quality slider?

Author:  hvz [ Fri Aug 12, 2022 11:24 am ]
Post subject:  Re: Weird GUI artifact...

Ah. This is a GUI issue that I haven't been able to figure out..... It happens with certain combinations of settings. It seems to be analyzing audio that's not yet generated. This doesn't affect the actual signal.

Author:  baldrick_nz [ Mon Aug 15, 2022 4:36 am ]
Post subject:  Re: Weird GUI artifact...

Quote:
Ah. This is a GUI issue that I haven't been able to figure out..... It happens with certain combinations of settings. It seems to be analyzing audio that's not yet generated. This doesn't affect the actual signal.
Thanks for the clarification Hans.

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/