Stereo Tool

Hello, maybe a very simple question for you guys, but I just can't figure it out. My output level is at max (at least I think so), barely see it moving / coming back. Everything else is running fine. How can I lower it. See videos on you tube that are almost the same as mine, don't know if I should adjust this?

Thanks in advance!

Greetings Willem

Output volume can be adjusted under I/O > Sound Cards. Choose the output that you are using and adjust the volume bar.

But if you barely see it moving, it means that either you're driving the clipper very hard or the output from multiband is not adjusted corresponding to the multiband drive. If you like the sound as is, just lower the volume, if you have a very dense and busy sound, lower one of the above mentioned.

Thank you very much for your reply, I will check it tonight.

Kind regards Willem