Stereo Tool https://forums.stereotool.com/ |
|
Insane Amount of static on output https://forums.stereotool.com/viewtopic.php?f=2&t=29106 |
Page 1 of 1 |
Author: | AudioG [ Fri Sep 18, 2020 8:44 pm ] |
Post subject: | Insane Amount of static on output |
Good Afternoon! I am trying to process a wav file with command line. Any file I process over 1gb, outputs with an insane amount of static. Could you please send me an example command for processing a 1gb+ wav file? Here are the two ways I have tried it with poor results on both. option #1: " stereo_tool_mac - - <before.wav>after.wav -s settings.sts "option #2 " stereo_tool_mac before.wav after.wav -s settings.sts |
Author: | MrKlorox [ Thu Sep 24, 2020 1:45 am ] |
Post subject: | Re: Insane Amount of static on output |
You might try Thimeo WatchCat for file-based processing. I don't have an actual solution to the command line issue, however. |
Author: | AudioG [ Thu Sep 24, 2020 6:06 pm ] |
Post subject: | Re: Insane Amount of static on output |
It was a bit depth mismatch, sorry forgot to post resolution! Thank you for the tip, I’ll look into it for the future. |
Author: | hvz [ Mon Sep 28, 2020 6:00 pm ] |
Post subject: | Re: Insane Amount of static on output |
Ow! So this means that there is not specifically an issue with files of > 1 GB? Because then I can close the ticket. |
Page 1 of 1 | All times are UTC+02:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |