Stereo Tool

Hi Hans,

I tried today to use the low latency output of ST and when I checked it ST crashed.
So I tried to uncheck Normal output and FM output, but the problem remains.
Restarted even the computer and restarted ST but same problem.
I even changed the sample rate to 48Khz (from 192) same problem.

I use a Intel PC with a i7 950 processor with 12Gb RAM
OS: Win 7/ 64bit Ultimate.
Soundcards: M-Audio 2626, Motu 828 mkIII, a Marian Trace Alpha.
And for Normal and FM output settings @192 Khz just works fine.

This is the setup,
#Playout system > VAC1 > ST7.60 > Normal out to M-Audio 2626 and FM out to Marian Trace Alpha > MPX to Transmitter
So I tried to load the LQ output to the Motu hardware, but it failed, also with another VAC channel it crashed.

Is there a bug, or is it just my settings? Can you help me out?

Thanks,
Gunther

If it crashes it's definitely a bug. Can you send me your settings? Thanks!

Stereotool crashes if low latency output and PNR Noise & Hum are used together.

Whoops just reading this, already sent the sts file to Hans, and BINGO right on the money.
with PNR Noise and Hum on ST crashes, without it works fine.

That should make it easy to fix

I remember that I programmed support for PNR in low latency mode, but it's probably not initialized properly when you did the analysis without LQLL mode on.

I have almost everything activated in my ST settings and than it's dificult for a troubleshooting report.
But Bluejay noticed, so well done
And thanks Hans for the quick feedback.