This is on purpose. Most of the settings aren't working for Digital mode, and those that are working are available in other places.
Ratio is under Speeds.
Separation is under Detection.
Max Ratio, Max Ratio At, Relative release, Big release acceleration and Sudden attack threshold, Window, Channel linking and Lowpass below are all Analog mode settings.
i kind of figured it was intentional but adjusting those settings for analog mode (which are not available in digital mode) do affect digital mode operation.
i actually prefer that those particular settings are able to be adjusted since i use the "window" mode for each band, it does have the effect i am looking for with MB1 in digital operation - the particular adjustments that i have made, that have the effect i need, are shown in the photo attached in my first post.
maybe i am asking too much and forgive me if i am, but would it be too much trouble to put those adjustments back for digital mode ?
if not, i can continue to make the adjustments i desire for digital mode, in analog mode (as i have been doing).
i also discovered, since i prefer using the "legacy" AGC (it just "works" way better), that some adjustments made on the "new" AGC (aka "current"), affect the operation of the legacy AGC.
the results of that have also provided certain effects i was targeting with the legacy AGC, so as far as i am concerned, its a good thing for me.
thanks for responding !