Quote:
Quote:
this highs vs high highs...
way different in beta 043 vs beta046. Kinda better in 043. ugh.. in beta 043 big difference is in slider highs vs rest, so there i can set it to 400% so it perfect fit with new slider at ~18%.
In beta046 i now need to set first slider to 200% and still not acting same as in beta 043, and new slider to ~5%.
So will be this section again changed or should we adapt to beta046?
O, the only difference *should* have been that there's a separate setting. Because the effect was pretty big, we decided to have a separate slider so disabling Legacy mode wouldn't sound completely different. I may have done something wrong though, if the behavior isn't the same.
The new version is already released.. but we can look into this again for the next release.
To make sure, "first slider" is highs vs rest, and "new slider" is the new one, and you're not using the "legacy highest vs lowest highs"?
No i dont use legacy slider, i realised that it's not legacy now. My current defaults settings for beta046 is 186% and 4% for those 2 sliders.
Maybe only wrong thing i see is steep filters, again, between highs and higher_highs
EDIT:
While new filter
"higest vs lowest highs" is prety much better then old one, there is now new problem, actually it's not new, kinda not covered or taken into account.
There is HUGE wide boost at around 5kHz (~1dB Q1.00) while clipper is on pressure. New
"higest vs lowest highs" slider should fix that too but it's kinda not wide enough. Actually it's prety much steep! It's so steep that everything over 3% pushes everything from 7 to 13kHz down (slope), and boosts ~14+kHz up, that much steep!
My oppinion it that it needs to be wider, to catch not from ~7kHz but from 5, even 4.
This is all without ABDP, With that ON, new range of problems.
Btw, "Leif's gap protection" should be On or Off. Everything other then 5 is disaster, especially 1.
Also with that off, things are way better. No 5kHz boost, so 'there' is problem(?)