Stereo Tool

I was going to post about an issue that was in beta 9 and earlier, but you seemed to have fixed it in this version 11. I'll still post what it was in case it pops back up.

Basically, right clicking the tray icon a second time to disable the bypass works, but the icon didn't change back to normal.

BEQ is also 1st band schained with HPF. What if i have 2 tight bass bands..

_________________
control point
control point2

i mentioned this before but im going to mention it again.
could the author of ST please implement peak-hold metering ?
this would be useful especially for the clipping level (advanced clipper), i could then see the maximum amount of clip level and adjust accordingly (clipping that occurs more than -6dB is audible distortion).
perhaps there are other areas of ST where peak-hold metering is useful as well.
thanks !

@EliteData: Definitely something we should put in the new GUI.

BETA016 is posted. Lots of bass clipper improvements, and Release Hold now works on non-constant speeds as well.

Are you really using a band split lower than 30 Hz or so? Or is your HPF set higher?

When you have any 2 bass bands, 2nd bass band goes pretty much down because no-steep (proper) filter, especially where we know that new HPF is way more wider than old.
And when its about HPF, I still think that there was nothing wrong with old HPF and it's better than new, it just needed to be sidechained like new wich was and is, good idea.

Bass at 100% quality - still artifacts and some pre-ring. Still needed atleast 130%. Zero fix for "limit" mode, huge pre rings and way different/worse bass clipping from ABDP.

_________________
control point
control point2

HI
HANS what about GRAIN in advanced clipper section bcs in this way we miss the freq above 9khz....we must go there to check in to have above freq....is way to have it in in default settings ON???
regards
P.S AFTER SHORT TIME THERE IS NO PROBLEM....SORRY

Hi, I still have never seen this issue. I'm unable to reproduce it. If you have any more info please let me know.

9.41b17 on server. Example links:

https://www.stereotool.com/download/ste ... 41-017.exe
https://www.stereotool.com/download/ste ... 41-017.exe
https://www.stereotool.com/download/dsp ... 41-017.exe

Some of those are still older versions, and some of them have crashes. I will post it when it's ready, which will be in a few hours.