| Stereo Tool https://forums.stereotool.com/ |
|
| VLevel Emulation Preset for Stereo Tool https://forums.stereotool.com/viewtopic.php?f=10&t=2064 |
Page 1 of 1 |
| Author: | michi95 [ Thu May 06, 2010 3:24 am ] |
| Post subject: | VLevel Emulation Preset for Stereo Tool |
I have created a very simple preset for Stereo Tool 5 that emulates VLevel's default characteristic. I have played some hundreds tracks - old and new from CD and my DVB MP2 (-3db, -6db, -9db pre-limited by the broadcasters). This Stereo Tool preset should replace VLevel. To me VLevel is now obsolete. There is only one small difference: The Stereo Tool preset adds a nice fade in characteristic. But this is only noticeable when you play an extraordinary loud (heavy compressed and limited) song and than start abruptly a new original very quiet (or dynamic) song. Background information here: viewtopic.php?p=5105#p5105 Copy this and paste it into an empty .txt file and rename it to VLevel Emu.sts (I am not sure, but I think the last line has to be empty ! - Hans ?) Quote: [Common]
Pre amplifier=10 Post amplifier=1 Extra loudness=1 Extra loudness - Very deep bass relative clipping level=0 Extra loudness - Allow extra lows (advanced)=0 Extra loudness - Allow extra highs (advanced)=0 Extra loudness - Punchy=0 Extra loudness - Max Punch peak=0.75 Extra loudness - Deep bass protection - Enabled=1 Extra loudness - Deep bass protection - Difference=0 Extra loudness - Deep bass protection - Value=0.638750076 Extra loudness - Forcibly remove DC component caused by Loudness=0 Bass protection - Enabled=1 Bass protection - Two steps=0 Bass protection - Clip level=140 Bass protection - Deep bass boost=0 Bass protection - Raise clip level if highs get above=150 Bass protection - Maximum clip level raise=35 Hard limit output=0 [Noise Gate] Enabled=0 Difference=0 Noise level=0.5 Relative noise gate level - Band 1=1 Relative noise gate level - Band 2=1 Relative noise gate level - Band 3=1 Relative noise gate level - Band 4=1 Relative noise gate level - Band 5=1 Relative noise gate level - Band 6=1 Relative noise gate level - Band 7=1 [Singleband Compressor] Enabled=1 Difference=0 Maximum volume=1 Attack speed=0.000001694 Decay speed=0.999000013 Above Top Limiter=0 [Pre Compressor] Enabled=0 Difference=0 Delay enabled=0 Remove remaining loud peaks=1 Maximum volume - Band 1=34920 Attack speed - Band 1=0.000005 Decay speed - Band 1=0.00025 Dual band=1 Relative expected volume of highs=0.649999976 Remove remaining peaks above (relative to maximum volume)=2 [Multiband Compressor] Enabled=0 Difference=0 Delay enabled=0 Maximum volume - Band -1=5379 Maximum volume - Band 0=6259.200195313 Maximum volume - Band 1=6748.200195313 Maximum volume - Band 2=6943.799804688 Maximum volume - Band 3=6846 Maximum volume - Band 4=6308.099609375 Maximum volume - Band 5=5672.400390625 Maximum volume - Band 6=4987.799804688 Maximum volume - Band 7=3716.399902344 Maximum volume - Band 8=1564.800048828 Attack speeds linked=1 Attack speed - Band -1=0.00005 Attack speed - Band 0=0.00005 Attack speed - Band 1=0.00005 Attack speed - Band 2=0.00005 Attack speed - Band 3=0.00005 Attack speed - Band 4=0.00005 Attack speed - Band 5=0.00005 Attack speed - Band 6=0.00005 Attack speed - Band 7=0.00005 Attack speed - Band 8=0.00005 Decay speeds linked=1 Decay speed - Band -1=0.0004 Decay speed - Band 0=0.0004 Decay speed - Band 1=0.0004 Decay speed - Band 2=0.0004 Decay speed - Band 3=0.0004 Decay speed - Band 4=0.0004 Decay speed - Band 5=0.0004 Decay speed - Band 6=0.0004 Decay speed - Band 7=0.0004 Decay speed - Band 8=0.0004 Above Top Limiter=0 Clipping enabled=1 Postprocessing enabled=0 Relative clip position - Band -1=3 Relative clip position - Band 0=3 Relative clip position - Band 1=2.5 Relative clip position - Band 2=2 Relative clip position - Band 3=2 Relative clip position - Band 4=2 Relative clip position - Band 5=2 Relative clip position - Band 6=2 Relative clip position - Band 7=2 Relative clip position - Band 8=2 Final limiter value=1 Final limiter decay speed=0.0007 Final limiter clipping=2.5 Equalizer enabled=0 Equalize before multiband-compression=1 Equalizer position - Band -1=1 Equalizer position - Band 0=1 Equalizer position - Band 1=1 Equalizer position - Band 2=1 Equalizer position - Band 3=1 Equalizer position - Band 4=1 Equalizer position - Band 5=1 Equalizer position - Band 6=1 Equalizer position - Band 7=1 Equalizer position - Band 8=1 [Stereo] Enabled=2 Stereo AZIMUTH Enabled=0 Stereo Image Enabled=0 Stereo Boost Enabled=0 Stereo Boost Excessive Reverb Protection Enabled=0 Delay enabled=0 Difference=0 Center bass=0 AZIMUTH limit=0 AZIMUTH change speed=0 Image phase amplifier=1 Image phase amplifier maximum angle=180 Image phase amplifier maximum separation strength=100 Image width amplifier=1 Extra phase shift=0 Mono or stereo only=0 Stereo Boost strength=1 Stereo Boost maximum amplification=3 Stereo Boost multiplier=1 Stereo Boost - Never reduce below original level=1 [Channel Delay] Enabled=0 Left Delay=0 [Output Filter] Enabled=0 Lowpass filter=15000 Highpass filter=20 Highpass filter linearity=Auto [Bass Boost] Enabled=0 Strength=1 Start lowpass frequency of input filter=0 End lowpass frequency of input filter=250 Start lowpass frequency of output filter=250 End lowpass frequency of output filter=350 Clip level=1.5 Clip level is relative to estimated maximum level=1 Preserve louder peaks=1 Difference=0 [Phase Rotator] Enabled=0 Start frequency=700 Start speed=1400 Number of rotations=4 Smoothness=0.979999959 [Final Limiter] Enabled=1 Difference=0 Pre-amp=1 Pre-limiter enabled=0 Pre-limiter relative volume=1.75 Reduced CPU processing=0 [FM Transmitter] Enabled=0 Pre-emphasize=0 Pre-emphasis time=50 Output is pre-emphasized=0 Stereo encoder enabled=0 RDS encoder enabled=0 Pilot signal volume=9 RDS signal volume=4.5 FM overdrive volume=1 RDS PS text=2s:STEREO/2s:TOOL/<1=1.5s,2..-2=2t,-1=1.5s:WWW.STEREOTOOL.COM RDS RadioText text=60s:Stereo Tool: Professional Audio Processing - http://www.stereotool.com/30s:Stereo Tool by Hans van Zutphen, 1999-2008 - http://www.stereotool.com RDS PTY=0 RDS PI=65535 RDS Alternative frequency 1=0 RDS Alternative frequency 2=0 RDS Alternative frequency 3=0 RDS Alternative frequency 4=0 RDS Alternative frequency 5=0 RDS Alternative frequency 6=0 RDS Alternative frequency 7=0 RDS Alternative frequency 8=0 RDS Alternative frequency 9=0 RDS Alternative frequency 10=0 RDS Alternative frequency 11=0 RDS Alternative frequency 12=0 RDS Alternative frequency 13=0 RDS Alternative frequency 14=0 RDS Alternative frequency 15=0 RDS Alternative frequency 16=0 RDS Alternative frequency 17=0 RDS Alternative frequency 18=0 RDS Alternative frequency 19=0 RDS Alternative frequency 20=0 RDS Alternative frequency 21=0 RDS Alternative frequency 22=0 RDS Alternative frequency 23=0 RDS Alternative frequency 24=0 RDS Alternative frequency 25=0 RDS TP=0 RDS TA=0 RDS Music=1 RDS Artificial Head=0 RDS Compressed=1 RDS Dynamic PTY=0 RDS RadioText Enabled=1 RDS ClockTime Enabled=1 FM Transmitter Calibration Enabled=0 MPX Oversampling mode=Follow main Quality setting FM Transmitter Calibration - Volume 20 Hz=1 FM Transmitter Calibration - Volume 40 Hz=1 FM Transmitter Calibration - Volume 80 Hz=1 FM Transmitter Calibration - Volume 160 Hz=1 FM Transmitter Calibration - Volume 320 Hz=1 FM Transmitter Calibration - Volume 640 Hz=1 FM Transmitter Calibration - Volume 1280 Hz=1 FM Transmitter Calibration - Volume 2560 Hz=1 FM Transmitter Calibration - Volume 5120 Hz=1 FM Transmitter Calibration - Volume 10240 Hz=1 FM Transmitter Calibration - Volume 19000 Hz=1 FM Transmitter Calibration - Volume 23000 Hz=1 FM Transmitter Calibration - Volume 28000 Hz=1 FM Transmitter Calibration - Volume 33000 Hz=1 FM Transmitter Calibration - Volume 38000 Hz=1 FM Transmitter Calibration - Volume 43000 Hz=1 FM Transmitter Calibration - Volume 48000 Hz=1 FM Transmitter Calibration - Volume 53000 Hz=1 FM Transmitter Calibration - Volume 57000 Hz=1 FM Transmitter Calibration - Phase shift 20 Hz=0.25 FM Transmitter Calibration - Phase shift 40 Hz=0 FM Transmitter Calibration - Phase shift 80 Hz=0 FM Transmitter Calibration - Phase shift 160 Hz=0.25 FM Transmitter Calibration - Phase shift 320 Hz=0 FM Transmitter Calibration - Phase shift 640 Hz=0 FM Transmitter Calibration - Phase shift 1280 Hz=0 FM Transmitter Calibration - Phase shift 2560 Hz=0 FM Transmitter Calibration - Phase shift 5120 Hz=0 FM Transmitter Calibration - Phase shift 10240 Hz=0 FM Transmitter Calibration - Phase shift 19000 Hz=0 FM Transmitter Calibration - Phase shift 23000 Hz=0 FM Transmitter Calibration - Phase shift 28000 Hz=0 FM Transmitter Calibration - Phase shift 33000 Hz=0 FM Transmitter Calibration - Phase shift 38000 Hz=0 FM Transmitter Calibration - Phase shift 43000 Hz=0 FM Transmitter Calibration - Phase shift 48000 Hz=0 FM Transmitter Calibration - Phase shift 53000 Hz=0 FM Transmitter Calibration - Phase shift 57000 Hz=0 [Direct soundcard access] Enabled=0 Device ID=Breakaway Pipeline 1 Volume=1 Buffer size=1 Send to Winamp=Nothing ASIO Override channel 1=4 ASIO Override channel 2=5 [Low latency output] Enabled=0 Device ID=ERROR: INVALID DEVICEID Volume=1 Buffer size=0.079999998 ASIO Override channel 1=2 ASIO Override channel 2=3 |
|
| Page 1 of 1 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|