Hi, sorry for the slow response! There are 2 possible causes, each of which should cause an error to be shown somewhere.
Since it affects both decoders, most likely, the encoder isn't sending data at the correct speed. This can be the case for example when using Virtual Audio Cable or VB Cable somewhere in the path.
It could be the Pi's as well, but if it's both, that's very unlikely (unless you're using the same type of sound card on both, and it's one that we haven't tested).
If it happens every few minutes, then the speed offset must be quite large. Most sound cards are within 0.001%, and MicroMPX will compensate for offsets up to 0.02%. Every few minutes would point at an offset somewhere in the range 0.2-0.5%.
|