All times are UTC+02:00




Post new topic  Reply to topic  [ 759 posts ]  Go to page Previous 110 11 12 13 1476 Next
Author Message
PostPosted: Thu Jan 11, 2018 7:43 pm 
User avatar

Joined: Sat Jan 05, 2013 11:14 pm
Posts: 160
Location: Antwerp
Hmmm ok, tried to load LQ output to feed VAC pipeline 3 to edcast and this baby appeared.
ST is standalone Beta, after this message ST freezes and has to be stopped by taakbeheer.


Attachments:
Screenshot_131.jpg
Screenshot_131.jpg [ 23.83 KiB | Viewed 1469 times ]

_________________
Stadsradio Vlaanderen Network
http://www.stadsradiovlaanderen.be
Top
   
PostPosted: Thu Jan 11, 2018 10:06 pm 
Site Admin
User avatar

Joined: Mon Mar 17, 2008 1:40 am
Posts: 9471
You're using an older beta. This problem was reported and fixed before, please use the latest - 8.55 BETA015 from viewtopic.php?f=14&t=23663&start=80


Top
   
PostPosted: Thu Jan 11, 2018 10:52 pm 
User avatar

Joined: Sat Jan 05, 2013 11:14 pm
Posts: 160
Location: Antwerp
Quote:
You're using an older beta. This problem was reported and fixed before, please use the latest - 8.55 BETA015 from viewtopic.php?f=14&t=23663&start=80
yup, het is opgelost, thanks :)

_________________
Stadsradio Vlaanderen Network
http://www.stadsradiovlaanderen.be


Top
   
PostPosted: Thu Jan 11, 2018 11:08 pm 
Site Admin
User avatar

Joined: Mon Mar 17, 2008 1:40 am
Posts: 9471
Mooi :)


Top
   
PostPosted: Sat Jan 13, 2018 1:47 am 
User avatar

Joined: Thu Jul 01, 2010 12:42 pm
Posts: 114
Location: Australia
ST 8.55 BETA015, the Basstadizer headroom slider in minimum reports 40% after load a imported profile... Is this normal?
Also at one stage was not able to turn on Difference, though cannot replicate again.


Top
   
PostPosted: Sat Jan 13, 2018 8:58 pm 

Joined: Thu Apr 21, 2011 1:52 pm
Posts: 35
Quote:
Quote:
- Compressor/limiter on input before AGC to handle extreme sounds? / 2nd AGC with higher threshold for voice tracks
that sounds like a very good idea. The new AGC is really wonderful in itself, but it still has its pitfalls. For example, the outdated AGC had the option of where it should start and, in addition, a compressor as protection. If there are extreme changes now, the new AGC reacts either too fast or too slow. I find it extremely difficult to find a good average. The built-in "Sudden Jump Protection" kills many of these cases, but not all of them.


in my case it helped a lot to raise the gatefreeze -30db & gateslowdown -29db & gatespeed x10

http://178.32.62.172:8911/mp3


Top
   
PostPosted: Sun Jan 14, 2018 12:01 am 
Site Admin
User avatar

Joined: Mon Mar 17, 2008 1:40 am
Posts: 9471
Quote:
ST 8.55 BETA015, the Basstadizer headroom slider in minimum reports 40% after load a imported profile... Is this normal?
Also at one stage was not able to turn on Difference, though cannot replicate again.
Yes you can't lower it further (would sound bad).


Top
   
PostPosted: Sun Jan 14, 2018 12:07 am 
Site Admin
User avatar

Joined: Mon Mar 17, 2008 1:40 am
Posts: 9471
Stereo Tool 8.55 BETA021

Thimeo WatchCat: big rewrite!
Windows 64 bit: http://www.stereotool.com/download/Thim ... 55-021.exe

Windows 32 bit:
Windows stand alone: http://www.stereotool.com/download/ster ... 55-021.exe
Winamp DSP: http://www.stereotool.com/download/dsp_ ... 55-021.exe
VST: http://www.stereotool.com/download/vst_ ... 55-021.dll

Windows 64 bit:
Windows stand alone: http://www.stereotool.com/download/ster ... 55-021.exe
VST: http://www.stereotool.com/download/vst_ ... 55-021.dll


CHANGES:
- Self test crashes
- Fix affinity for Linux and Mac - Mac doesn't support it.
- Edwin's bass effect - is that done now? (Maybe an extra HPF?) -> Not needed for now, based on preliminary tests...
- Put Bass EQ under license
- Do we need multiple Basstardizer bands? -> Doesn't seem like it. Not for now.
- Remove Hans mode from Bass EQ? -> Hid it (Extreme Tweaker mode, Matt mode is default, made it a pulldown instead of a boolean to clarify its behavior).
- Octaviafm extra logging? - Waiting. Once we know the cause I'll run a new build. But I'm not going to hold off releasing the current version, since 1. this issue doesn't have any side effects anymore and 2. it very likely isn't new. -> Nothing heard anymore
- Would multiple where_i_am start points improve attack? YES!!!! Think about how to implement it...

OLDER CHANGES:
- Enabling low latency output caused crashes
- NAN recovery added to Basstardizer
- Top area of GUI made a bit higher, not all menu items fit before
- Bigger font and widgets on 4K screens
- Added Basstardizer
- Remove warnings that were shown for things that weren't even enabled.
- Fixed NAN in 8.54 in several versions in the clipper (reported by 1 person, appears to have been settings-related).
- Matt's bass effect Ready to get feedback, see "BASS EQ" before or between multibands! See note below.
- Fixed Mac multiband compressor gate error after NAN recovery.
- Add Breakaway Pipeline warning
- Add low input level warning
- Add too little AGC action warning
- Add too much noise gate warning
- Add too much BS412 action warning
- Added ASIO latency setting.
- Made streaming with libVLC easier, WARNING though, the audio quality is still the VLC streaming audio quality, there are better encoders out there. This only affects the stand alone versions.

NOTE: Bass EQ
1. This thing should not really be needed because there's already Auto EQ. However Matt Levin insisted that it's useful, especially now that they are playing very old Christmas music, so let's try it out!
2. There are 2 modes: Matt Mode (see checkbox) or Hans mode (unchecked). In Matt mode, the highest band is not adjusted but it is used to determine the levels. So in the last stage, the highest band is in bypass mode, but the other bands respond as if it's working as well. So the bass is adjusted compared to the full spectrum. In Hans mode, the highest band is ignored completely, so if you use 2 bass bands, they are adjusted to match each other, but not the rest of the audio.

TODO:
- Spectrum displays are broken in 4K mode
- Compressor/limiter on input before AGC to handle extreme sounds? / 2nd AGC with higher threshold for voice tracks Added, may need new mode. Waiting for feedback.
- MPEG detection is too insensitive now -> Probably fixed Waiting for feedback
- UECP UDP mode Waiting for feedback
- Add auto save to Linux build Waiting for feedback
- VST delay appears to be wrong - Phase Delay and Threads
- VST version no 4K
- Backup input - fix overshoot display
- Backup input - check stereo
- Fix web server long URL issue Test release mode needed
- TA/TP via MagicRDS. Auto-enable TP if TA is used? (no)
- Added THIMEORT in ASCII RDS mode.
- Scrolling through presets in 4K mode locks screen (crashes).
- Revisit new Hard Limit / Final Limiter with Matt & Wes - Settings removed Waiting for final feedback.
- RDS: Add timeout for TA
- RDS: Add PTYN
- Improved multipath protection
- Improved Stereo Image phase limiter
- Pilot-only output for 9 , works but needs to be sent back to O9SG
- New compressor mode. Check all weird settings, optimize, new peak mode, remove faster attack/release, add setting for max release, fix max attack/release speed controls. Things to check: "Peak", "Peak mode", "Feedback", "Feedback^2", "Exponential release", "Max attack speed", "Max release speed".
- Make 9/9sg pilot generation smooth for external feeds for DARC etc.
- Bass mono fiter to reduce multipath
- NAB text & ads?
- Is pre AGC affecting audio levels? (With BS412) -> Not specifically for BS412, but it slightly reduces the level even if set a lot higher. Probably needs some offset.
- Aanvraag uren
- AM streaming output
- Basstardizer fadeout (Edwin)?
- Add AM presets
- Check MB2 1% something (see FB chat about crackling sound, which was ok in 8.00). Test with Rhodes54 preset -> Ok. But Spideys Web (7.41 vs 8.54) is different, let's test that.

- 18 Hz trigger tone
- Reduce extreme stereo
- Raspberry Pi "gedeelde bibliotheek" melding.
- Check out Butt
- Add libVLC instability warning
- Loudness meter (also for streaming)
- Omnia.9 set Stereo signal. Probably fixed? Wait for answer.
- Omnia.9 test/fix logging
- Omnia.9 AutoPilot add flag for generating noise above pilot?
- WatchCat website
- Triple stuff
- Thumb up/down in GUI for presets

- SCA2 use as backup, feed to output without processing, bypassing normal chain. Use to have FM receiver as backup, and then just feed the full signal to the output.
- uMPX 24x2ch interface
- One bass page

- GUI: Hide disabled stuff, far less confusing / much cleaner interface.
- Talk to chip
- 2 jaar
- Fardau
- -24 dB side chain range?


Top
   
PostPosted: Sun Jan 14, 2018 3:46 am 

Joined: Sat Nov 10, 2012 2:16 am
Posts: 45
Location: Australia
Hi Hans

Version 8.55 BETA021 - Standalone 64 Bit
Windows 10 64Bit, 4K monitor
Cosmetic (does not impact on audio quality)

Processing - Absolute Highs - Input and Output spectrum windows not filling correctly.
Repair - Delossifier - Input and Output spectrum windows not filling correctly.
Attachment:
AbsoulteHighsWindowError.jpg
AbsoulteHighsWindowError.jpg [ 88.3 KiB | Viewed 1076 times ]
Rossco


Top
   
PostPosted: Sun Jan 14, 2018 9:38 am 

Joined: Sun Feb 03, 2013 2:39 pm
Posts: 289
With a fresh install (no ini file) the size of the DSP GUI stays the same as with 8.54 on a 4k monitor but the font size increases so that the words don't fit the buttons anymore. (With an old ini file present while installing the GUI itself will increase its size, too.)

Multiband quick overview doesn't fit the GUI no matter what.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 759 posts ]  Go to page Previous 110 11 12 13 1476 Next

All times are UTC+02:00


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited