Stereo Tool

Feedback, questions, settings and more...
      Home         Download         Donate         Register         Forums         Help   
It is currently Tue Sep 26, 2017 8:08 pm

All times are UTC+02:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Mon Jan 30, 2017 12:48 pm 

Joined: Mon Sep 23, 2013 11:17 am
Posts: 5
Just thought I'd share what I've been using ST for lately. I have on my bench a prototype transmitter I'm designing, the ST test tones have come in very useful for testing modulation, audio response and different varicap bias voltages etc... I only wish the slider to select the test tone was more linear above 15khz. I'm using a trace alpha card also for its flat response which I also confirmed on the scope, it gives a perfect square wave at 30hz.

I'm using two varicaps, one fed with the PLL control voltage to set the frequency and keep it locked, and the other for modulation. Now I've found that the bias voltage to the modulation varicap makes a difference to the audio response above 10khz and also phase angle between the 19khz pilot and RDS. The deviation also changes when the transmitter frequency is changed, requiring the modulation level to be set again for 75khz deviation. To get around all this I'm scaling the bias voltage to the modulation varicaps so the modulation level and audio response is consistent across the band. I have also gone for a longer lock time using a "lead lag" configuration in the PLL loop filter, so a 30hz square wave will modulate at 75khz (or very close to it within 2khz) without the PLL trying to correct it.

The trouble with some transmitters out there is they use a single varicap to tune the whole band and modulate the MPX signal, hence leaves very little room for 75khz deviation, the audio response is not flat as a result, phase difference occurs between pilot and RDS, and depending on the loop filter, low audio frequencies will have a hard time modulating.


Top
   
PostPosted: Mon May 15, 2017 3:28 am 

Joined: Thu Apr 27, 2017 3:54 am
Posts: 5
gareth41 wrote:Just thought I'd share what I've been using ST for lately. I have on my bench a prototype transmitter I'm designing, .
Hi! Is there any way I can contact you directly regarding this transmitter?

-- nutz4audio


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+02:00


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited