All times are UTC+02:00




Post new topic  Reply to topic  [ 31 posts ]  Go to page Previous 1 2 3 4
Author Message
PostPosted: Thu Jun 14, 2018 7:31 pm 

Joined: Thu Jun 14, 2018 7:09 pm
Posts: 1
I have two transmitters on the same frequency within 15 miles of each other (SFN) with audio delivered to each TX site via an Internet stream (as no radio STL links are possible).

The transmitters have GPS timing inputs (10 MHz and 1 PPS) insuring carrier and pilot frequency lock, however there is currently no synchronization of the audio between the two sites, hence a poor listening experience. The transmitters have L/R analog, AES/EBU and composite (MPX on BNC connector) inputs.

My question: How might Stereo Tool be deployed in this scenario to synchronize the audio? One instance of ST running at each site? If "yes", how is the synchronization accomplished? That is, is the ST synchro function 'dynamic'; is it able to correct for 'drifting' time delay that might be caused by the nature of Internet packet delivery? Or (more likely) am I thinking about this from inside the box?

Thanks for any insight!


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 31 posts ]  Go to page Previous 1 2 3 4

All times are UTC+02:00


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited