Stereo Tool https://forums.stereotool.com/ |
|
Please help with OMNIA SST and micrompx https://forums.stereotool.com/viewtopic.php?f=6&t=14645 |
Page 1 of 1 |
Author: | juanex [ Tue Feb 07, 2017 7:23 pm ] |
Post subject: | Please help with OMNIA SST and micrompx |
Hi to all. Please, can you help me with micrompx encoder/decoder configuration? I am testing OMNIASST. I have read the manual and can not find information on how to configure them. Thanks a lot. |
Author: | hvz [ Wed Feb 08, 2017 11:32 am ] |
Post subject: | Re: Please help with OMNIA SST and micrompx |
We're waiting for the manual to be finished. For now, I hope this will get you started: How to setup MicroMPX:
If the decoder is on the same LAN or VPN as the encoder, then you can use its local IP address (usually a 192.168 or 10. number). If it's not, and it's placed behind a router, you'll have to forward a port to it in the router settings to be able to reach it, and use its external IP address in the encoder. You can find this by going to a site such as http://whatismyip.com/ , on the decoding pc. If you're on a LAN or VPN, it's possible to use multicasting to send the data to many IP addresses on the same network. To do this, use a multicase IP address - this is an address that ends at .255. So for example, 192.168.100.255 will stream to 192.168.100.1, 192.168.100.2 etc. If you start the MicroMPX decoder, and the encoder is running or is started afterwards, you'll see a few warnings about pilot phase differences pop up when it connects. This is normal, and an easy way to see that the signal starts to arrive. Once the phase difference is connected (usually within about 1 second), the logging should stop completely. If things keep being logged, something is wrong. (Occasionally there can be some extra logging a few seconds after connecting, but that should be all). |
Author: | zhta1972 [ Fri Feb 10, 2017 8:14 pm ] |
Post subject: | Re: Please help with OMNIA SST and micrompx |
Is MicroMPX usable with normal stereo tool ? Thank you |
Author: | hvz [ Sat Feb 11, 2017 1:24 am ] |
Post subject: | Re: Please help with OMNIA SST and micrompx |
Not at this point. We're for now only selling a separate decoder and built-in encoders. |
Page 1 of 1 | All times are UTC+02:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |