All times are UTC+02:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Direct Wire Settings
PostPosted: Sun Nov 20, 2016 6:35 pm 

Joined: Fri Apr 15, 2016 9:38 pm
Posts: 2
Hi, I'm using Stereo Tool on a standalone PC with a Juli@ soundcard. The balanced "line in" is fed to the
1/4 inch jack input but the audio supplied to the ShoutCast streaming software is the non processed
audio.When monitoring the audio out and I bypass Stereo Tool the level and audio quality drop but
the audio at the streamer end remains the same as the input.To overcome this I used Direct Wire
and this now works but the audio quality seems to have a slight phase problem and the ST input level meters
are lower than I would expect.Direct Wire is connected from ASIO 1 & 2 to NME 1 & 2 not sure if this is
the best setting .The only soundcard input you can select on the streamer software is Juli@ 12.


Top
   
 Post subject: Re: Direct Wire Settings
PostPosted: Mon Dec 19, 2016 6:42 pm 
Site Admin
User avatar

Joined: Mon Mar 17, 2008 1:40 am
Posts: 9448
The real problem is probably that you can't use 3/4 in the streaming program. I'm not sure what DirectWire does in this case, but I would kinda expect it to combine the incoming signal with the signal that you're outputting. If you could use 3/4 as input, and don't use them for anything else, that would give you the clean Stereo Tool output.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+02:00


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited