Stereo Tool https://forums.stereotool.com/ |
|
MicroMPX Command Line Parameters https://forums.stereotool.com/viewtopic.php?f=2&t=25777 |
Page 1 of 1 |
Author: | bmcglynn [ Sat Jan 12, 2019 5:32 pm ] |
Post subject: | MicroMPX Command Line Parameters |
Hello, Can some share the MicroMpx command line parameters for Raspberry Pi? Thanks in advance. |
Author: | Mathijsco [ Sat Jan 12, 2019 8:22 pm ] |
Post subject: | Re: MicroMPX Command Line Parameters |
Run micrompx -h. But I recommend using the web GUI version instead. |
Author: | bmcglynn [ Thu Jan 17, 2019 12:42 pm ] |
Post subject: | Re: MicroMPX Command Line Parameters |
Quote:
Run micrompx -h. But I recommend using the web GUI version instead.
This is for the Raspberry Pi - so I didn't think there was a GUI version. I tried "-h" and "--help", and it does not give any help information on the Raspberry Pi version.Thanks. |
Author: | Mathijsco [ Thu Jan 17, 2019 2:15 pm ] |
Post subject: | Re: MicroMPX Command Line Parameters |
If it doesn't say anything with -h you already have the web (!) GUI version. Open a web browser and open http://<ip-address of the raspberry pi>:8080. Or 127.0.0.1:8080 on the pi itself. |
Author: | hvz [ Tue Jan 22, 2019 10:28 am ] |
Post subject: | Re: MicroMPX Command Line Parameters |
There are 2 files: MicroMPX - this is the command line version with command line parameters. -h will show you what they do MicroMPX_Decoder - this is the web gui version. No -h option. |
Page 1 of 1 | All times are UTC+02:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |