Stereo Tool

I don't know if it's a bug, or if I have some settings wrong or what... but I've tried ST 9.22 on at least four different computers with the same result on each. The two input meters randomly drop to zero for approximately 100ms every 1-3 seconds on average. It doesn't seem to be linked to the graphics card or drivers as I've tried it on an NVidia, ATI and Intel-based GPU each with the same result.

The waveform display under Input & Output on the other hand may be just me overlooking a setting somewhere, but I cannot find anything in ST related to it to save my life. On every computer I've run ST on, the waveform display does not show a summed mono signal, it displays only the left channel for both input and output, even after I perform a Factory Reset. Depending on the song, on occasion I'll look over at the screen and see dead air on the scope, but I'll see the right channel still has audio playing on the level meters.



Also what's with the number nine being shown as an emdash on the forums now??! Even in the message post box I type a nine and it shows up as "—"

EDIT:: I noticed the emdash issue on another Website, I think I have a corrupted font on my PC. Ignore that part!

Hi,

The flashing input meters have been fixed in 9.24 bèta 012. So in the upcoming release this will be fixed. The waveform display indeed shows the left channel only.

_________________
Imaging producer & Stereo Tool audio processing consultant

Thanks for letting me know. ST truly has been one of the best purchases I've made. Keep up the amazing work guys!